Reconditioned, Rebuild and Used Land Rover 3.0 Engine Service UK Supplied and Fitted

Land Rover 3.0 Engine Supply & Replacement Specialists, Save Up to 40%

Engine Rebuild is the ultimate one-stop garage where you get the quality engine complete service for Land Rover 3.0 without jumping through hoops. With years of experience, all engine services are done by a professional team of mechanics. Every engine in our inventory is thoroughly tested and inspected. From the moment you arrive at Engine Rebuild's workshop until the final handover, you can expect precise engine service nothing less than excellence. And the amazing thing is, all these engine services are offered at very competitive prices. Many of our clients save up to 40% on complete supply and fitting service.

The Land Rover 3.0 engine is the 3.0-litre diesel fitted to Discovery, Defender and Range Rover models across the UK. Most failed units we see are the 306DT TDV6 and SDV6. Later Land Rovers use the AJ20D6 Ingenium 3.0 diesel. Both are Land Rover 3.0 engines and both need the correct engine code before any rebuild or replacement.

These Land Rover 3.0 engines pull and tow well. They also fail in known ways. Crankshaft damage, low oil pressure, turbo failure and timing belt wear put many Discovery 4, Discovery 5 and Defender vehicles off the road. Driving on with a knock or an oil light usually wrecks the Land Rover 3.0 engine.

Engine Rebuild rebuilds, reconditions and replaces Land Rover 3.0 engines at our in house rebuilding facility. We also supply used Land Rover 3.0 engines. Engine diagnostics come first. We check the registration, VIN and engine code so the unit we rebuild or fit is the right Land Rover 3.0 engine. You can take supply only or full supply and fit. Recovery is available if the vehicle will not drive. Contact us on the given number for a quote.

Common Land Rover 3.0 Engine Problems, Causes and Our Engine Solution

Land Rover 3.0 Engine Rebuild, Reconditioned and Used Replacement Options

A Land Rover 3.0 engine rebuild uses your own 306DT or AJ20D6. We strip the Land Rover 3.0 engine at our in house rebuilding facility. The block, crankshaft, bearings, pistons, rods and heads are cleaned and measured. Worn parts are machined or replaced. This Land Rover 3.0 engine rebuild makes sense when the block and crank can still be saved.

A reconditioned Land Rover 3.0 engine is the better route when the original unit is too far gone. We take a compatible Land Rover 3.0 engine, strip it, inspect it and rebuild it to a set spec. You get a reconditioned 306DT or AJ20D6 ready to fit. A used Land Rover 3.0 engine is the lower cost choice when budget or speed comes first. We still match the Land Rover 3.0 engine code, power output and emissions spec.

Engine Rebuild does not guess the spec from engine size alone. The same Land Rover 3.0 engine family covers TDV6, SDV6 and Ingenium 3.0 diesel. We check registration, VIN and engine code before we quote. You can buy supply only or book supply and fit. Warranty options cover rebuilt, reconditioned and used Land Rover 3.0 engines. Contact us on the given number for the Land Rover 3.0 engine options that match your vehicle.

Land Rover 3.0 Engine Diagnostics, Supply and Fit

Engine diagnostics come first on every Land Rover 3.0 engine job. A knock, smoke or limp mode is not always a dead engine. Injectors, EGR, DPF and turbo faults can look like Land Rover 3.0 engine failure, so we test first. If the crank, bearings or block are damaged, we move to a Land Rover 3.0 engine rebuild or replacement.

Our 4-step process is the same for every Land Rover 3.0 engine. We assess the vehicle and the fault. We match the Land Rover 3.0 engine code and check compatibility. We rebuild your engine or prepare a reconditioned or used Land Rover 3.0 engine. We then supply, fit and hand the vehicle back with warranty support. Recovery and fitting support is available when the Land Rover 3.0 engine has failed and the vehicle cannot be driven.

Engine Rebuild works on Land Rover 3.0 engines for Defender, Discovery 4, Discovery 5 and matching Range Rover Sport and Vogue models. Popular codes include 306DT and AJ20D6. All work goes through our in house rebuilding facility. Get a quote on the given number with your registration and fault.